工程实践
Neon Flex Installation Guide for Architectural Projects
2026年7月28日
Installation steps for silicone neon flex — bending, mounting, cutting, sealing, drivers, and commissioning on facade and podium work.
Neon Flex Installation Guide
Quick Answer: Install neon flex by respecting minimum bend radius, using approved adhesives for the substrate, sealing every cut and feed for IP67, mounting drivers in accessible locations, and commissioning with full-load night inspection of color uniformity.
Pre-Install Checks
- Verify BOM revision matches approved sample - Dry-fit bends on mock section - Confirm driver locations and cable routes
Bending & Routing
Do not exceed minimum radius — kinks create dark spots and open circuits. Use factory corner pieces or cut-and-join where drawings require tight geometry.
Mounting
Clean substrate; apply adhesive per manufacturer TDS and temperature window. Add mechanical clips on long vertical runs where specified.
Cutting & Sealing
1. De-energize circuit 2. Cut at marked point 3. Install end cap / heat-shrink / potting per IP kit 4. Test insulation before energizing
Commissioning
- Measure current per feed - Verify DMX scenes if applicable - Photograph night appearance for handover
Q: Can installers splice in the field? A: Yes with approved kits — unapproved splices void IP and warranty.
Q: When should samples be approved? A: Before bulk order — validate CCT, dimming, and installation in a mockup or sample room.
Conclusion
Installation quality defines outdoor life. Follow Mihoray termination instructions bundled with OEM shipments.
About Mihoray
Mihoray is a professional LED strip and neon flex manufacturer based in China, providing OEM and ODM lighting solutions for commercial, hospitality, architectural and landscape lighting projects worldwide.